Reference Guide

mask Enter the mask of the IP address in the slash prefix length
format (for example, /24). The mask appears in command
outputs in dotted decimal format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
redistribute – redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
S5000
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
748
IPv6 Border Gateway Protocol (IPv6 BGP)