Reference Guide

CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
Related
Commands
show ip bgp ipv6 unicast neighbors – displays IPv6 routing information exchanged
by BGP neighbors.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
S5000
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0::0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
S5000
Syntax
neighbor {ipv6-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} timers command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
744
IPv6 Border Gateway Protocol (IPv6 BGP)