Reference Guide

peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Peers that are enabled within a peer group are disabled when their peer group is
disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP
neighbor or BGP peer group. Use this command with caution as it terminates the
specified BGP sessions. When a neighbor or peer group is shutdown, use the show
ip bgp ipv6 unicast summary command to confirm its status.
Related
Commands
show ip bgp ipv6 unicast summary – displays the current BGP configuration.
show ip bgp ipv6 unicast neighbors – displays IPv6 routing information exchanged
by BGP neighbors.
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
S5000
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-
name
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Defaults Disabled.
Command
Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes received by the neighbor but
does not reset the peer-session.
IPv6 Border Gateway Protocol (IPv6 BGP)
743