Reference Guide

Parameters
neighbor ip-
address | peer-
group-name
Enter the keyword neighbor followed by one of the options
listed below:
• ip-address of the neighbor in IP address format of the
neighbor
• peer-group-name of the neighbor peer group
restart-time
seconds
Enter the keywords restart-time followed by the
maximum number of seconds needed to restart and bring up
all peers. The range is 1 to 3600 seconds. The default is
120
seconds.
stale-path-time
seconds
Enter the keywords stale-path-time followed by the
maximum number of seconds to wait before restarting a
peer’s stale paths. The default is 360 seconds.
role receiver-
only
Enter the keywords role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults As above
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In
Receiver only mode, BGP saves the advertised routes of peers that support this
capability when they restart.
bgp log-neighbor-changes
Enable logging of BGP neighbor resets.
S5000
Syntax
bgp log-neighbor-changes
To disable logging, use the no bgp log-neighbor-changes command.
Defaults Enabled.
Command
Modes
ROUTER BGP
Command
History
Version 9.0(1.3) Introduced on the S5000.
IPv6 Border Gateway Protocol (IPv6 BGP)
709