Reference Guide

Command
Modes
EXEC
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ipv6 nd dad attempts – Configure system to set the flow label field in the packets
to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
S5000
Syntax
show ipv6 interface type slot/port [brief] [configured] [stack—
unit unit-number]]
Parameters
interface type
slot/port
(OPTIONAL) Enter the interface keyword followed by the
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured
interfaces.
stack-unit unit-
number
(OPTIONAL) View information for a specific stack-unit. The
range is 0 to 11.
Defaults none
692
IPv6 Basics