Reference Guide

ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
S5000
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps Enter the maximum number of error packets to be generated
per second. The range is 1 to 200, where 0 disables the rate-
limiting.
Default 100 pps
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
S5000
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the field to be filled by
protocol operations, use the no ipv6 flowlabel-zero command.
Default Disabled
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If the flowlabel value is already set for BGP or SSH, the system defaults to the
already configured value. All packets on the same connection are considered part
of the same flow by the system. For new connections, set the new flowlabel to
zero.
684
IPv6 Basics