Reference Guide

seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 100 count
Dell#
test cam-usage
Verify that enough ACL CAM space is available for the IPv6 ACLs you have created.
S5000
Syntax
test cam-usage service-policy inputinput-policy—map name
Parameters
input policy-
map name
Enter the name of the policy-map to verify.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when
verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a
policy on a single (or the first of several) interfaces. It is most useful when a policy
is applied across multiple interfaces; it can reduce the impact to CAM usage across
subsequent interfaces.
The following describes output for the test cam-usage command shown in the
Example below.
Stack-unit Lists the stack-unit(s) that are checked. Entering all shows
the status for stack-units.
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for stack-units and
port-pipes in the chassis.
CAM Partition Shows the CAM profile of the CAM.
Available CAM Identifies the amount of CAM space remaining for that
profile.
Estimated CAM
per Port
Estimates the amount of CAM space the listed policy
requires.
Status Indicates whether or not the policy is allowed in the CAM
IPv6 Access Control Lists (IPv6 ACLs)
675