Reference Guide

ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
S5000
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
S5000
Syntax
ipv6 access-list access-list-name
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-
name
Enter the as the access list name as a string, up to 140
characters.
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet
is dropped.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your switch ocumentation.
Related
Commands
show config – views the current configuration.
660
IPv6 Access Control Lists (IPv6 ACLs)