Reference Guide

Column
Heading
Description
Route Source Identifies how the route is configured in Dell Networking OS.
Active Routes Identifies the best route if a route is learned from two
protocol sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes
down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes
are advertised, then information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the
memory usage of those routes. If there are no routes
configured in the Dell Networking OS, this line does not
appear.
Example
Dell>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related
Commands
show ip route – displays information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
S5000
Syntax
show ip traffic
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes keywords in output for the show ip traffic command
shown in the Example below.
644
IPv4 Routing