Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
• For a stack-unit, enter the keyword stack-unit
followed by the stack-unit number. The range is 0 to 11.
brief (OPTIONAL) Enter the keyword brief to view a brief
summary of the interfaces and whether an IP address is
assigned.
configured (OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output for the show ip interface command shown in
the Example below.
Field Description
TenGigabitEthe
rnet 0/0...
Displays the interface’s type, slot/port, and physical and line
protocol status.
Internet
address...
States whether an IP address is assigned to the interface. If
an IP address is assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound
access...
Displays the name of the any configured incoming access
list. If none is configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the
interface.
636
IPv4 Routing