Reference Guide

Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address to be used
to forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00
Port VId EC
-------------
BLK HOLE 0 0
Dell>
Related
Commands
clear ip fib stack-unit – clears the FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S5000
Syntax
show ip flow interface [type slot/port {source-ip-address
destination-ip-address } {protocol [tcp | udp | number ]}
{source-port port-number destination-port port-number}
Parameters
interface type
slot/port
Enter the keyword interface followed by of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
source-ip-
address
Enter the source IP address.
634
IPv4 Routing