Reference Guide

Z10-3 (perm, OK) - IP 192.71.23.1
Dell#
Related
Commands
traceroute – views the DNS resolution.
ip host – configures a host.
show ip cam stack-unit
Display CAM entries for the S5000 switch.
S5000
Syntax
show ip cam stack-unit unit-number port-set pipe-number [ip-
address mask [longer-prefixes] | ecmp-group | member-info |
detail | summary]
Parameters
stack-unit unit-
number
Enter the keyword stack-unit followed by the unit
number. The range is 0 to 11.
port-set pipe-
number
Enter the keyword port-set followed by number of the
port-pipe. Values are 0 or 1.
ip-address
mask [longer-
prefix]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. Enter the keyword longer-
prefixes
to view routes with a common prefix.
detail Enter the keyword detail to display the group index ID
used by the ecmp routes in the CAM.
member-info Enter the keyword member-info to display the group index
used by the ecmp, the number of egress ports (members) for
the ecmp, and the port details of each member. The detail
information under member-info gives the MAC address,
VLAN ID, and gateway of every member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip cam command shown in the Example
below.
IPv4 Routing
631