Reference Guide

Defaults Enabled; the hops field in the DHCP message header is incremented by default.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command disables the incrementing of the hops field when boot requests are
relayed to a DHCP server through Dell Networking OS. If the incoming boot
request already has a non-zero hops field, the message is relayed with the same
value for hops. However, the message is discarded if the hops field exceeds 16, to
comply with the relay agent behavior specified in RFC 1542.
Related
Commands
ip helper-address – specifies the destination broadcast or host address for DHCP
server requests.
show running-config – displays the current configuration and changes from the
default values.
ip host
Assign a name and IP address to be used by the host-to-IP address mapping table.
S5000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped
to the name.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
618
IPv4 Routing