Reference Guide

Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the ip
name-server
command.
Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip name-server – specifies a DNS server.
show hosts – Views the current bindings.
ip domain-name
Configure one domain name for the switch.
S5000
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can only configure one domain name with the ip domain-name command.
To configure more than one domain name, configure the
ip domain-list
command up to six times.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
616
IPv4 Routing