Reference Guide

Request, hops = 0, XID = 0xda4f9503, secs = 0, hwaddr =
00:60:CF:20:7B:8C, teaddr = 0.0.0.0
00:12:42 : %RELAY-I-BOOTREQUEST: Forwarded BOOTREQUEST for
00:60:CF:20:7B:8C to 14.4.4.2
00:12:42 : %RELAY-I-PACKET: BOOTP REPLY (Unicast) received at
interface 14.4.4.1 BOOTP Reply,
hops = 0, XID = 0xda4f9503, secs = 0, hwaddr = 00:60:CF:20:7B:
8C, teaddr = 113.3.3.17
00:12:42 : %RELAY-I-BOOTREPLY: Forwarded BOOTREPLY for
00:60:CF:20:7B:8C to 113.3.3.254
Dell#
Related
Commands
ip helper-address – specifies the destination broadcast or host address for the
DHCP server request.
ip helper-address hop-count disable – disables the hop-count increment for the
DHCP relay agent.
debug ip icmp
View information on the internal control message protocol (ICMP).
S5000
Syntax
debug ip icmp [interface-type slot/port] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface-type
slot/port
(OPTIONAL) Enter the interface type followed by slot/port or
number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count followed by the count
value. The range is 1 to 65534. The default is Infinity.
610
IPv4 Routing