Reference Guide

clear ip fib stack-unit
Clear all forwarding information base (fib) entries in the specified stack-unit (use this command with
caution, refer to Usage Information below).
S5000
Syntax
clear ip fib stack—unit unit-number
Parameters
stack-unit unit-
number
Enter the keyword stack-unit followed by the unit
number. The range is 0 to 11.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use this command to clear Layer 3 CAM inconsistencies.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib stack-unit – shows FIB entries.
clear ip route
Clear one or all routes in the routing table.
S5000
Syntax
clear ip route {* | ip-address mask }
Parameters
* Enter an asterisk (*) to clear all learned IP routes.
ip-address
mask
Enter a specific IP address and mask in dotted decimal
format to clear that IP address from the routing table.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip route – assigns an IP route to the switch.
show ip route – views the routing table.
IPv4 Routing
607