Reference Guide

Related
Commands
show arp retries – displays the configured number of ARP retries.
arp timeout
Set the time interval for an ARP entry to remain in the ARP cache.
S5000
Syntax
arp timeout minutes
Parameters
seconds Enter the number of minutes. The range is 0 to 35790. The
default is 240 minutes.
Defaults 240 minutes (4 hours)
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
show interfaces – displays the ARP timeout value for all available interfaces.
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries
from the content addressable memory (CAM).
S5000
Syntax
clear arp-cache [interface-type slot/port | ip ip-address] [no-
refresh]
Parameters
interface-type
slot/port
(OPTIONAL) Enter the interface type followed by slot/port or
number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
IPv4 Routing
605