Reference Guide

Passthrough Commands
The following are passthrough commands supported on the S5000.
show stack-unit port-group portmode
Display the fibre channel port-group mode information.
S5000
Syntax
show system stack-unit unit-number port-group portmode
Parameters
stack-unit unit-
number
Enter the keywords stack-unit then the unit number. The
range is from 0 to 11.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.1(1.0) Introduced on the S5000.
Example
Dell#show system stack-unit 0 port-group portmode
PortGroupId Ports Mode(Curr Boot) Mode(Next Boot)
0 0,1 FC FC
1 2,3 FC FC
2 4,5 ETH FC
3 6,7 FC ETH
4 8,9 FC FC
5 10,11 FC FC
Dell#
Related
Commands
stack-unit port-group portmode — configures a fibre channel port group to enable
passthrough ethernet mode.
stack-unit port-group portmode
Configure a fibre channel port group to enable passthrough ethernet mode.
S5000
Syntax
stack-unit unit-number port—group number portmode ethernet
To change to Fibre Channel mode, use the no stack-unit unit-number port
—group number portmode ethernet command.
Fibre Channel Interface Commands
601