Reference Guide

FCoE map over server-facing Ethernet ports. A server sees the FC port with its
applied FCoE map as an FCF port.
Example
Dell(conf)#interface fibrechannel 3/0
Dell(conf-if-fc-3/0)#exit#
Related
Commands
show interfaces fibrechannel — displays the configuration of a Fibre Channel
interface.
show interfaces fibrechannel
Display the configuration of a Fibre Channel interface.
S5000
Syntax
show interfaces fibrechannel type slot/port
Parameters
fibrechannel
slot/port
Enter the keyword FibreChannel then the slot/port
numbers. Valid slot numbers are from 0 to 11. The port range
is from 0 to 47.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show interfaces fibrechannel command to display the current
configuration and operation of a Fibre Channel port on the S5000.
NOTE: In release 9.0.(1.3), an FC module can be installed only in expansion
slot 0 (ports 0 to 11) on an S5000 switch.
The following table describes the show interfaces fibrechannel command
output shown in the following example.
Fibre Channel Interface Commands
595