Reference Guide

In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must
be unique. Use one FCoE map to access one SAN fabric. You cannot use the same
FCoE map to access different fabrics.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map
map-name command in Interface configuration mode.
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters
in FCoE maps.
feature fc
Enable Fibre Channel capability on the S5000.
S5000
Syntax
feature fc
Defaults The S5000 is not enabled to operate in Fibre Channel mode.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use this command to configure the S5000 to interoperate with Fibre Channel
devices in SAN fabrics.
Enter the no feature fc command to disable the Fibre Channel command-line
interface and free memory resources allocated to Fibre Channel operation.
Example
Dell(conf)#feature fc
Related
Commands
show interfaces fibrechannel — displays the configuration of a Fibre Channel
interface.
member — alias
Add devices to an alias.
S5000
Syntax
member name
To remove devices from the alias, use the no member name command
Fabric Services Commands
581