Reference Guide

Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member – adds a physical interface to the LAG.
interface – configures a physical interface.
interface loopback – configures a Loopback interface.
interface null – configures a null interface.
interface vlan – configures a VLAN.
shutdown – disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the
LAG to be also in “oper up” status.
S5000
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is 1 to 16. The default is 1.
Defaults 1
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you use this command to configure the minimum number of links in a LAG that
must be in “oper up” status, the LAG must have at least that number of “oper up”
links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.
port-channel failover-group
Access PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.
S5000
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group
command.
564
Interfaces