Reference Guide

traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, you must enter no shutdown on the port channel interface
and at least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
interface port-channel – creates a port channel interface.
interface vlan – creates a VLAN.
show ip interface – displays the interface routing status. Add the keyword brief to
display a table of interfaces and their status.
speed (Management interface)
Set the speed for a Management interface.
S5000
Syntax
speed {10 | 100 | 10000 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 10/100
Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to
1000 Mb/s (1 Gb/s).
auto Enter the keyword auto to set the interface to auto-
negotiate its speed.
Defaults auto
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is supported only on a Management interface.
Related
Commands
interface ManagementEthernet – configures the Management port on the system
(either the primary or standby stack-unit).
duplex (Management interfaces) – configures duplex mode on physical interfaces
with the speed set to 10/100.
558
Interfaces