Reference Guide

===================================
SFP 1 Data Ready state Bar = False
SFP 1 Rx LOS state = True
SFP 1 Tx Fault state = False
SFP 1 Rate Select state = False
SFP 1 RS state = False
SFP 1 Tx Disable state = False
===================================
SFP 1 Temperature High Alarm Flag = False
SFP 1 Voltage High Alarm Flag = False
SFP 1 Tx Bias High Alarm Flag = False
SFP 1 Tx Power High Alarm Flag = False
SFP 1 Rx Power High Alarm Flag = False
SFP 1 Temperature Low Alarm Flag = False
SFP 1 Voltage Low Alarm Flag = False
SFP 1 Tx Bias Low Alarm Flag = False
SFP 1 Tx Power Low Alarm Flag = False
SFP 1 Rx Power Low Alarm Flag = True
===================================
!-------output truncated -------------------------!
Related
Commands
interface – configures a physical interface on the switch.
show ip interface – displays Layer 3 information about the interfaces.
show interfaces – displays information on a specific physical interface or virtual
interface.
show inventory – displays the S5000 switch components (including media), Dell
Networking OS version including hardware identification numbers, and configured
protocols.
show range
Display all interfaces configured using the interface range command.
S5000
Syntax
show range
Command
Modes
INTERFACE RANGE (config-if-range)
Command
History
Version 9.0(1.3) Introduced on the S5000.
Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface tengigabitethernet 2/0 - 1
interface tengigabitethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
Related
Commands
interface – configures a physical interface on the switch.
show ip interface – displays Layer 3 information about the interfaces.
556
Interfaces