Reference Guide

show interfaces – displays information on a specific physical interface or virtual
interface.
show interfaces transceiver – displays the physical status and operational status of
an installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
S5000
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port] transceiver
Parameters
tengigabitether
net
For a 10G interface, enter the keyword
tengigabitethernet followed by the slot/port
information.
fortyGigE For a 40G interface, enter the keyword fortyGigE followed
by the slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show interfaces transceiver command output
shown in the Example below.
Table 5. Output Fields for the show interfaces
transceiver Command
Field Description
Rx Power measurement type Output depends on the vendor, typically either
“Average” or “OMA” (Receiver optical
modulation amplitude).
Temp High Alarm threshold Factory-defined setting, typically in
Centigrade. Value differs between SFPs and
SFP+.
Voltage High Alarm threshold Displays the interface index number used by
SNMP to identify the interface.
Bias High Alarm threshold Factory-defined setting. Value can differ
between SFP and SFP+.
Interfaces
551