Reference Guide

2. Use the mac access-list standard or mac access-list extended command. Include a

name for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).

You can return to CONFIGURATION mode by using the exit command.

IP ACCESS LIST Mode

You must use the ip access-list standard or ip access-list extended command to enter IP

ACCESS LIST mode and configure either standard or extended access control lists (ACLs).

To enter IP ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the ip access-list standard or ip access-list extended command. Include a name

for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).

You can return to CONFIGURATION mode by using the exit command.

ROUTE-MAP Mode

You must use ROUTE-MAP mode to configure a route map.

To enter ROUTE-MAP mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Use the route-map map-name [permit | deny] [sequence-number] command. The prompt

changes to include (route-map).

You can return to CONFIGURATION mode by using the exit command.

PREFIX-LIST Mode

You must use PREFIX-LIST mode to configure a prefix list.

To enter PREFIX-LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to

include (conf-nprefixl).

You can return to CONFIGURATION mode by using the exit command.

AS-PATH ACL Mode

You must use AS-PATH ACL mode to configure an AS-PATH Access Control List (ACL) on the S5000. For

more information, refer to Access Control Lists (ACL).

To enter AS-PATH ACL mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the ip as-path access-list command. Include a name for the AS-PATH ACL. The

prompt changes to include (config-as-path).

You can return to CONFIGURATION mode by using the exit command.

CLI Basics