Reference Guide

show interfaces – displays information on a specific physical interface or virtual
interface.
show interfaces status
Display a summary of interface information or specify a stack-unit and interface to display status
information on that specific interface only.
S5000
Syntax
show interfaces [type slot/port] status
Parameters
interfaces type
slot/port
(OPTIONAL) Enter the interfaces keyword followed by the
interface type and slot/port or number information, then
enter the
status keyword.. Valid slot numbers are 0-11. The
valid port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a range of interfaces, enter the keyword range
followed by slot/port number.
• For a Fibre Channel interface, enter the keyword
FibreChannel followed by slot/port numbers. The port
range is 0 to 47.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
548
Interfaces