Reference Guide

Hardware is DellEth, address is 5c:f9:dd:ee:ff:c2
Current address is 5c:f9:dd:ee:ff:c2
Pluggable media present, SFP+ type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850nm
SFP+ receive power reading is -3.1158dBm
Interface index is 36242440
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d23h34m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
355 packets, 40162 bytes, 0 underruns
0 64-byte pkts, 355 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
355 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:23:23
Dell#
Related
Commands
show interfaces – displays information on a specific physical interface or virtual
interface.
show interfaces dampening
Display interface dampening information.
S5000
Syntax
show interfaces dampening [[interface-type slot/port] [summary]
[detail]]
Parameters
interface-type
slot/port
(Optional) Enter the interface type followed by slot/port or
number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
Interfaces
543