Reference Guide

Prompt Interface Type

FTOS(conf-if-

fo-0/0)#

fortyGigEfollowed by slot/port information (ports 48, 52, 56, or 60)

FTOS(conf-if-

fc-0/0)#

FibreChannel followed by slot/port information (ports 0–47)

FTOS(conf-if-

lo-0)#

loopback followed by a number (range 0–16383)

FTOS(conf-if-

nu-0)#

null followed by zero (0)

FTOS(conf-if-

po-0)#

port-channel number (range 1–128)

FTOS(conf-if-

vl-0)#

vlan followed by VLAN id number (range 1–4094)

FTOS(conf-if-

ma-0/0)#

managementethernet followed by slot/port information (port 0)

FTOS(conf-if-

range)#

Designated interface range (used for bulk configuration).

LINE Mode

You must use LINE mode to configure the console or virtual terminal parameters.

To enter LINE mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the line command. Include the keywords console or vty and their line number available on

the switch. The prompt changes to include (config-line-console) or (config-line-vty).

You can exit this mode by using the exit command.

TRACE-LIST Mode

You must use TRACE-LIST mode to configure a Trace list.

To enter TRACE-LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to

include (conf-trace-acl).

You can exit this mode by using the exit command.

MAC ACCESS LIST Mode

You must use the mac access-list standard or mac access-list extended command to enter

MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs).

To enter MAC ACCESS LIST mode:

1. Verify that you are logged in to CONFIGURATION mode.

CLI Basics