Reference Guide

NOTE: You must remove all other configurations on the port before you can
remove the hybrid configuration from the port.
Example
Dell(conf)#interface te 7/0
Dell(conf-if-te-7/0)#portmode hybrid
Dell(conf-if-te-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged gi 7/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: TenGigabitEthernet 7/0
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-v1-10)#no untagged te 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged te 7/0
Dell(conf-if-vl-20)#interface te 7/0
Dell(conf-if-te-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport – displays the configuration of switchport (Layer 2)
interfaces on the switch.
switchport – places the interface in a Layer 2 mode.
vlan-stack trunk – specifies an interface as a trunk port to the Stackable VLAN
network.
rate-interval
Configure the traffic sampling interval on the selected interface.
S5000
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data.
The range is 30 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the
number of seconds designated here will round to the
multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated, it will round to 30;
45 to 59 seconds will round to 45, and so forth.
536
Interfaces