Reference Guide

interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
S5000
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is 1 to
4094.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
For more information about VLANs and the commands to configure them, refer to
the Virtual LAN (VLAN) Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not
supported in VLANs. IP ACLs are supported. For more information, refer to the
Access Control Lists (ACL) chapter.
Example (Single
Range)
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
interface – configures a physical interface.
interface loopback – configures a loopback interface.
interface null – configures a null interface.
interface port-channel – configures a port channel group.
show vlan – displays the current VLAN configuration on the switch.
shutdown – disables/enables the VLAN.
tagged – adds a Layer 2 interface to a VLAN as a tagged interface.
untagged – adds a Layer 2 interface to a VLAN as an untagged interface.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
S5000
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
530
Interfaces