Reference Guide

interface ManagementEthernet
Configure the Management port on the system (either the primary or standby stack-unit).
S5000
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet followed by slot/
port information. Slot range is 0 to 1. Port number is 0.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address
command to assign an IP address to the Management port.
If your system has more than one stack-unit, use the show redundancy
command to display which stack-unit is the primary unit.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
management route – configures a static route that points to the Management
interface or a forwarding router.
duplex (Management interfaces) – configures duplex mode on a management
interface whose speed is set to 10/100 Mb/s.
speed (Management interface) – clears the FIB entries on a specified stack-unit.
interface null
Configure a Null interface on the switch.
S5000
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
524
Interfaces