Reference Guide

Related
Commands
show running-config – displays the flow configuration parameters (non-default
values only).
show interfaces – displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
S5000
Syntax
interface type slot/port
Parameters
interface type
slot/port
Enter the interface keyword followed by the interface
type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a range of interfaces, enter the keyword range
followed by slot/port number.
• For a Fibre Channel interface, enter the keyword
FibreChannel followed by slot/port numbers. The port
range is 0 to 47.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
522
Interfaces