Reference Guide

Defaults Without an interface specified, the command clears all interface dampening
counters.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
After you enter the clear counters command and verify the results with the
show interfaces command, the line rate is not reset to 0.00%.
Example
Dell#clear dampening tengigabitethernet 1/2
Clear dampening counters on Te 1/2 [confirm] y
Dell#
Related
Commands
show interfaces dampening – displays interface dampening information.
dampening – configures dampening on an interface.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
S5000
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used
at the selected port:
• short = For 1-meter and 3-meter cable lengths.
• medium = For 5-meter cable length.
• long = For 10-meter and 15-meter cable lengths.
Defaults medium
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command only works on ports that the system recognizes as CX4 ports. The
show interfaces command shown in the Example below describes an attempt
to configure an XFP port in an S25P with the command after inserting a CX4
converter into the port.
NOTE: When using a long CX4 cable, to avoid errors, configure the cable
using the cx4-cable-length short command only.
Interfaces
515