Reference Guide

22
Interfaces
The commands in this chapter are supported in Dell Networking OS on the S5000 switch.
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
• UDP Broadcast
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol
(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.
S5000
Syntax
clear counters [interface-type slot/port] [vrrp [{[ipv6]
vrid }] | learning-limit]
Parameters
interface-type
slot/port
(OPTIONAL) Enter the interface type followed by slot/port or
number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For the management interface on the stack-unit, enter
the keyword ManagementEthernet followed by slot
number (0-1) and port number zero (0).
Interfaces
513