Reference Guide

ip igmp snooping last-member-query-interval
The last member query interval is the maximum response time inserted into Group-Specific queries sent
in response to Group-Leave messages.
S5000
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-
query-interval command.
Parameters
milliseconds Enter the interval in milliseconds. The range is 100 to 65535.
The default is 1000 milliseconds.
Defaults 1000 milliseconds
Command
Modes
INTERFACE VLAN
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This last-member-query-interval is also the interval between successive Group-
Specific Query messages. Use this command to change the last-member-query
interval.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
S5000
Syntax
ip igmp snooping mrouter interface type slot/port
To delete a specific multicast router interface, use the no igmp snooping
mrouter interface type slot/port command.
Parameters
interface type
slot/port
Enter the interface keyword followed by the interface
type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
Internet Group Management Protocol (IGMP)
509