Reference Guide

Parameters
interface type
slot/port
(OPTIONAL) Enter the interface keyword followed by the
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN does not
yield results.
Example
Dell#show ip igmp interface
TenGigabitEthernet 0/0 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/5 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/6 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 0/7 is up, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 7/9 is up, line protocol is up
Internet address is 10.87.5.250/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP activity: 0 joins, 0 leaves
IGMP querying router is 10.87.5.250 (this system)
IGMP version is 2
Internet Group Management Protocol (IGMP)
505