Reference Guide

show ip igmp groups
View the IGMP groups.
S5000
Syntax
show ip igmp groups [group-address [detail] | detail |
interface-type slot/port [group-address [detail]]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the
IGMPv3 source information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command displays the IGMP database, including configured entries for either
all groups on all interfaces, all groups on specific interfaces, or specific groups on
specific interfaces.
The following describes the show ip igmp groups command shown in the
Example below.
Field Description
Group Address Lists the multicast address for the IGMP group.
Interface Lists the interface type, slot and port number.
Mode Displays the IGMP version used.
Internet Group Management Protocol (IGMP)
503