Reference Guide

include source
address
(OPTIONAL) Enter the keyword include followed by the
source address, in dotted decimal format (A.B.C.D), for which
a static entry needs to be added.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
A group in include mode must have at least one source address defined. In
exclude mode, if you do not specify a source address, Dell Networking OS
implicitly assumes all sources are included. If you do not specify either
include or
exclude, Dell Networking OS implicitly assumes a IGMPv2 static join.
Command Limitations
• Only one mode (include or exclude) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original
mode must be unconfigured.
• If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration
for the group.
Related
Commands
show ip igmp groups – displays IGMP group information.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
S5000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
502
Internet Group Management Protocol (IGMP)