Reference Guide

ip igmp ssm-map
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
S5000
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them
with (*,G) state, use the ip igmp ssm-map std-access-list source-
address command.
Parameters
std-access-list Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address Specify the multicast source address to which the groups are
mapped.
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard – creates a standard access list to filter based on IP address.
ip igmp static-group
Configure an IGMP static group.
S5000
Syntax
ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group
address [exclude [source address]] | [include {source
address}]}
command.
Parameters
group address Enter the group address in dotted decimal format (A.B.C.D).
exclude source
address
(OPTIONAL) Enter the keyword exclude followed by the
source address, in dotted decimal format (A.B.C.D), for which
a static entry needs to be added.
Internet Group Management Protocol (IGMP)
501