Reference Guide

ip igmp query-interval
Change the transmission frequency of IGMP general queries sent by the Querier.
S5000
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds Enter the number of seconds between queries sent out. The
range is 1 to 18000. The default is 60 seconds.
Defaults 60 seconds
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
S5000
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds Enter the number of seconds for the maximum response
time. The range is 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
500
Internet Group Management Protocol (IGMP)