Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
Command
Modes
EXEC
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN does not
yield results.
debug ip igmp
Enable debugging of IGMP packets.
S5000
Syntax
debug ip igmp [group address | interface-type slot/port]
• To disable IGMP debugging, use the no debug ip igmp [group address
| interface] command.
• To disable all debugging, use the undebug all command.
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface-type
slot/port
Enter the interface type followed by slot/port or number
information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed
by a VLAN id number from 1 to 4094.
496
Internet Group Management Protocol (IGMP)