Reference Guide

Defaults Enabled.
Command
Modes
CONFIGURATION-GVRP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
gvrp enable – enables GVRP on physical interfaces and LAGs.
protocol gvrp – access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
S5000
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all}
command.
Parameters
join Enter the keyword join followed by the number of
milliseconds to configure the join time. The range is 100 to
147483647 milliseconds. The default is
200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave followed by the number of
milliseconds to configure the leave time. The range is 100 to
2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all followed by the number of
milliseconds to configure the leave-all time. The range is 100
to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command
Modes
CONFIGURATION-GVRP
Command
History
Version 9.0(1.3) Introduced on the S5000.
482
GARP VLAN Registration (GVRP)