Reference Guide

debug gvrp
Enable debugging on GVRP.
S5000
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config Enter the keyword config to enable debugging on the
GVRP configuration.
event Enter the keyword event to enable debugging on the JOIN/
LEAVE events.
pdu Enter the keyword pdu followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11.
The valid port numbers for each interface type are listed
below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
Defaults Disabled.
Command
Modes
EXEC
Command
History
Version 9.0(1.3) Introduced on the S5000.
disable
Globally disable GVRP.
S5000
Syntax
disable
To re-enable GVRP, use the no disable command.
GARP VLAN Registration (GVRP)
481