Reference Guide

Command
Modes
• CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The maximum number of supported FIP snooping sessions that you configure is
displayed in the running configuration (if it is not the default value) and in show
fip-snooping config output.
If you configure a smaller number of supported sessions than was previously
configured, all current FIP snooping sessions continue and a warning message is
displayed. If a greater number of sessions are active with an ENode, additional
sessions are not allowed as long as the total number is greater than the newly
configured limit.
When the maximum number of FIP snooping sessions for an ENode are already
active on the switch, a log message is recorded if the ENode tries to log in to
initiate another session.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
S5000
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-
mode fcf
command.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
NOTE: The FCoE-Trusted Port mode used to connect to another FIP snooping
bridge (bridge-bridge link) is not supported on the S5000.
FCoE Transit
463