Reference Guide

ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when
maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.
S5000
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-
paths
Specify the maximum number of ECMP for a route. The
range is 2 to 64.
path-fallback Use the keyword path-fallback to enable this feature. If
you enable the feature, re-enter this keyword to disable the
feature.
Defaults 16
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then
reload the system for the new settings to take effect.
Related
Commands
show ip cam stack-unit – Display content-addressable memory (CAM) entries for
an S5000 switch.
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution will begin being monitored
on an ECMP link bundle.
S5000
Syntax
link-bundle-distribution trigger-threshold [percent]
Parameters
percent Indicate the threshold value when traffic distribution will start
being monitored on an ECMP link bundle. The range is 1 to
90%. The default is 60%.
Command
Modes
EXEC Privilege
456
Equal Cost Multi-Path Overview (ECMP)