Reference Guide

State Machine Type is Feature
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf
TLV Pkts
show interfaces pfc
Displays the PFC configuration applied to ingress traffic on an Ethernet interface, including priorities and
link delay.
S5000
Syntax
show interfaces type slot/port pfc {summary | detail}
Parameters
type slot/ port
pfc
Enter the Ethernet interface type and slot/port or number
information followed by the keyword pfc. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
{summary |
detail}
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To clear the PFC TLV counters, use the clear pfc counters interface
port-type slot/port command.
The following table describes the show interface pfc {summary} command
output shown in the Example below.
Table 3. Output Fields for the show interface pfc
Command
Field Description
Interface Interface type with stack-unit number
and port number.
Admin mode is on Admin is enabled PFC admin mode is on or off with a list of
the configured PFC priorities . When the
430
Data Center Bridging (DCB)