Reference Guide

PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
show interfaces dcbx detail
Displays the DCBx configuration on an Ethernet interface.
S5000
Syntax
show interfaces type slot/port dcbx detail
Parameters
interfaces type
slot/port
Enter the interfaces keyword followed by the Ethernet
interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface
type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are
48, 52, 56, and 60.
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To clear DCBx frame counters, use the clear dcbx counters interface
stack-unit/port command.
The following table describes the show interface dcbx detail command
output shown in the Example below.
422
Data Center Bridging (DCB)