Reference Guide

debug dcbx
Enable DCBx debugging.
S5000
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBx debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Enter the type of debugging, where:
• all: enables all DCBx debugging operations.
• auto-detect-timer: enables traces for DCBx auto-
detect timers.
• config-exchng: enables traces for DCBx configuration
exchanges.
• fail: enables traces for DCBx failures.
• mgmt: enables traces for DCBx management frames.
• resource: enables traces for DCBx system resource
frames.
• sem: enables traces for the DCBx state machine.
• tlv: enables traces for DCBx TLVs.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
S5000
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is 1 to FF.
414
Data Center Bridging (DCB)