Reference Guide

Configure DCBx operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBx configuration on a port, use the show interface
dcbx detail command.
dcbx version
Configure the DCBx version used on the interface.
S5000
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBx version, use the dcbx version {auto | cee | cin |
ieee-v2.5} command.
Parameters
auto | cee | cin
| ieee-v2.5
Enter the DCBx version type used on the interface, where:
• auto: configures the port to operate using the DCBx
version received from a peer.
• cee: configures the port to use CEE (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBx
1.0).
• ieee-v2.5: configures the port to use IEEE 802.1az
(Draft 2.5).
Defaults Auto
Command
Modes
INTERFACE PROTOCOL LLDP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
DCBx requires that you enable LLDP to advertise DCBx TLVs to peers.
Configure DCBx operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBx configuration on a port, use the show interface
dcbx detail
command.
Data Center Bridging (DCB)
413