Reference Guide

stack-unit unit-
number
Enter the keyword stack-unit followed by a number. The
range is 0 to 11.
stack-unit all
stack-ports all
Enter the keyword stack-unit followed by all stack-
ports all
to clear the counters on all interfaces.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
dcb enable
Enable data center bridging.
S5000
Syntax
dcb enable
To disable DCB, use the no dcb-enable command.
Defaults Enabled
Command
Modes
CONFIGURATION
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
By default, DCB is enabled and link-level flow control is disabled on all S5000
interfaces.
To disable DCB, enter the no dcb enable command.
Related
Commands
dcb-map– creates a DCB map to configure PFC and ETS parameters and apply the
PFC and ETS settings on Ethernet ports.
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
S5000
Syntax
dcb-map map-name
410
Data Center Bridging (DCB)